R I V E T T / R O C K E T T
55
Attach both ends of the pushrods, making
sure the seals are on the outside of the
radio box.
Use Goop or CA to glue the pushrod seals
to the outside of the radio box. Make sure
the seals are centered on the pushrod
holes. Allow to dry
.
Install your antenna.
Setup
Grease the flex cable.
Slide the cable through the strut, into the
engine collet.
Leave a ¼ inch gap between the drive dog
and strut.
Tighten the collet.
Wrap your receiver, failsafe and battery
pack in foam rubber.
Mount the switch.
Turn the transmitter on first, then the
receiver.
Make sure the trims are centered.
Put the rudder servo arm on. It should be
parallel with the servo, and 90 degrees to
the pushrod. Use the sub trim function, if
your radio has it. If not, get it as close as
you can.
Attach the rudder to the pushrod. Is the
rudder straight? If not, adjust the clevis or
ball link until it is.
Be sure to put the screw in the servo arm…
Содержание RIVETT
