R I V E T T / R O C K E T T
54
Put the boat on your stand. This is where it
will live, when it’s not in the water.
Sharpen the turn fin. Using a file (or
grinder) and 220 grit paper, sharpen the
right side of the turn fin only.
The front should be sharp, and the back
flat.
Put the turn fin in its mount, and bolt it onto
the sponson with the ¼-20 screws, into the
blind nuts.
Install the engine.
Install the servos.
Install the shaft tube.
Install the strut, pushing the end of the
shaft tube all the way in. Leave the strut
loose in the brackets.
Put the boat on a flat surface. You can
hang the turn fin over the side of the table.
Block up the transom 7/8 inch from the
table.
Push the strut to the table so that it is flat
on the table while the transom is 7/8 off the
surface.
Tighten the strut in the brackets.
Install the rudder assembly
Install the flex shaft.
Install the fuel tank and fuel lines. Place
foam rubber under the tank, and use a few
rubber bands to hold the tank in place.
Install the bulkhead fittings and water
outlet.
Install exhaust or tuned pipe.
Install water lines.
Push the threaded end of the rudder and
throttle pushrods through the big end of the
pushrod seals.
Содержание RIVETT
