R I V E T T / R O C K E T T
53
Once the hull is dry, wipe it down with
alcohol. Use a tack cloth lightly to remove
any dust.
Spray a light coat of primer, inside and out.
Let this flash for a few minutes, and spray
a heavy coat on.
Let sit overnight.
When the primer is dry, use spot putty to fill
any nicks or surface imperfections.
When dry, wet sand with 400 on the rubber
block.
If you are happy with the surface, spray on
another medium coat of primer.
When dry, wet sand with 600 or 800.
Use compressed air or a vacuum to
remove the dust on the inside and outside
of the hull.
Wipe down the entire boat with alcohol.
Use a tack cloth to lightly wipe all surfaces.
Spray your color coats.
When cured, wet sand with 800+ and clear
coat the entire hull.
Make sure the clear is completely cured
before final assembly.
Apply your decals.
Wipe the area with alcohol, allow to dry.
Remove the backing from the decal. If you
have trouble removing the backing, press
or squeegee it firmly, and try again.
Align the decal and press firmly to surface.
Roll or squeegee in place. Remove transfer
sheet from top of decal.
Final assembly
Before you bolt anything to the hull, give it
a good coat of paste wax.
Содержание RIVETT
