R I V E T T / R O C K E T T
46
Deck notch after sanding.
Smooth, rounded nose.
Rockett decks being test fitted.
Once everything has cured, check the area of
the side decks near bulkhead 2. Are the
decks glued to this bulkhead? If not, you can
use medium CA, squirted in the notch, to
glue it down. Use accelerator.
You can cut the top of bulkhead 2 off at this
point. Sand and seal the cut areas.
Plane and sand the deck flush, and keep the
radius at the rear of the sponsons smooth.
The nose should be rounded off, and blunt.
Do not make the nose sharp, as this will
make the hull unpredictable at speed. Keep
the radius to at least ¼ inch.
Fill the notches with wood filler.
Rockett
The Rockett deck is done in 5 pieces;
Two deck sides, two sponson decks and one
deck center.
The deck halves are not the same.
It is important that you test fit and fully
understand how the deck fits on before you
epoxy.
The deck halves are attached one at a time,
allowed to cure, and the center deck is
attached at the front.
Содержание RIVETT
