R I V E T T / R O C K E T T
44
Cowling fits between deck halves.
Rivett deck clamped, taped and epoxied.
Notch detail.
The deck halves are not the same. It is
important that you test fit and fully understand
how the deck fits on before you epoxy.
The deck halves are attached one at a time,
allowed to cure, and the center deck is
attached at the front.
The cowling covers most of the open center
section.
Before you glue anything, lets test fit the
deck.
Using a couple of small clamps, clamp one
deck to the deck support near the front and
rear. Line up the rear of the
sponson with the deck, and line up the deck
inside edge with the centerline you drew on
the deck support.
When the deck is lined up correctly, add
clamps along the deck support. Clamp the
nose as well.
Using masking tape, tape the rear portion of
the deck down. Tape at the transom too.
Continue taping the sponson portion, and
tape the sponson transom, as it will want to
bow upward.
Tape the sponson deck, and note how well
the notch closes. Does the notch need to be
opened up slightly? It there a gap?
Take the time to get the notch as perfect as
possible, as this is the part of the boat that
everybody sees.
Содержание RIVETT
