R I V E T T / R O C K E T T
37
Shaft tube installed.
Note 1/4 inch gap between drive dog and strut.
Exhaust goes thru hole in bulkhead 3.
Remove the strut and shaft tube (again!),
and cut the front of the tube on your mark.
Deburr this end.
Bolt the strut and shaft tube in place again.
Slip the cable into the strut and tube, being
absolutely certain that the cable is all the
way into the collet.
Measure the distance from the back of the
strut to the front of the drive dog. Subtract
¼ inch from this measurement.
This is the amount to cut off the front of the
cable to leave a ¼ inch drive dog to strut
gap.
Exhaust
We used a quiet pipe in our hydro, and
recommend that you use a quiet pipe or
effective muffler, as loud boats lose ponds!
Install the engine in the hull with the 90
degree header in place.
Leave the carb off, for now.
Slip the pipe onto the header and adjust it
to the proper length.
If the pipe is long, you may have to cut out
a hole in bulkhead 5. Using the quiet pipe,
we didn’t have to.
Make your pipe mount now, while the deck
is not on.
We used a simple piece of ½ inch marine
(or aircraft) ply, on edge.
Содержание RIVETT
