R I V E T T / R O C K E T T
35
Marking 2-
3/4 inches to the left…
Strut and rudder centerlines.
Rudder and strut mounted.
Hardware
Draw a center line on the transom, top to
bottom. Draw a parallel line 2-3/4 to the
left
of the center line.
Assemble your strut to the bracket, and
adjust the strut so that it is all the way up in
the bracket.
Hold the strut on the transom so that it is
about ½ inch off the bottom, align it to the
center line and mark one hole.
Drill this hole and bolt the strut to the
transom with this one screw and nut.
Align the strut to the center line and tighten
the screw.
Take a step back and eyeball the strut to
make sure it, and your center line are
straight. If all looks good, mark and drill the
other 3 holes.
Mount the rudder on the left side of the
transom, aligning it to the line you drew
earlier. Mount it the same way, eyeballing it
before you drill the last 3 holes.
The rudder should extend at least 2 inches
below the strut.
Mark and drill the hole for the rudder
pushrod in the transom.
Because it is so long, we used a ¼ inch
carbon tube and
“4-40” pushrod material
for our rudder pushrod.
We used a solder clevis at the servo end,
and a 4-40 ball link at the rudder end.
Make sure the pushrod doesn’t rub on any
bulkheads. If it does, open the hole until it
is clear.
Содержание RIVETT
