R I V E T T / R O C K E T T
27
Sponson bottoms ready for trimming and
sanding.
Rear non trip being test fitted in place.
Note bevels in rear non trip.
Back to the boat:
Make sure that it has been at least 2 hours
since you glued the bottom sheeting to the
sponson.
Rear Non Trip
The rear non trip sides are designed to go
inside of the hull, between the sides and
bottom.
They must be beveled in order to fit.
Hold one of the rear non trips near the
back of the hull, and mark it for the bevels
needed to get it inside.
Use your plane and 80 grit to make the 45
degree bevels.
Test fit the non trip in place. You may have
to trim the front point slightly, so that it fits
tightly in place.
When satisfied with the fit, glue in place
with thin CA and accelerator. Glue again.
Repeat on other side.
Содержание RIVETT
