R I V E T T / R O C K E T T
10
Blind nuts epoxied to turn fin doubler.
Our building board is two pieces of 3/4x10x48
MDF Cover with wax paper.
Fitting bulkheads to stringers before wicking thin
CA into joints.
Install the two blind nuts to the turn fin
doubler with 30 minute epoxy.
Frame assembly
Cover your building board with waxed
paper or clear plastic wrap. We don’t want
to glue the boat to the building board…
Start by assembling bulkheads 1, 2 and 3
to the side stringers. Make sure the
bulkheads are in the correct slots, and
facing the correct way. The tabs on the
bulkheads are all offset to the right.
Push the bulkheads all the way into the
stringers, until they are flush at the bottom
of the stringer. You may need to tap the
bulkheads with a block of wood or a small
hammer to get them fully seated.
Содержание RIVETT
