36
Setup
Set the strut so that it is level with the
tub bottom, and touching the ski bottom.
You may have to cut some of the strut
so that it sits on the very end of the ski
sheeting.
Turn on the radio.
Make sure that the steering trim is in the
center. Move the steering servo arm so
that it is straight up. Put the servo arm
screw in.
Mount the throttle servo arm so that it is
at about 2 o’clock with the trigger at
neutral.
Put the servo arm screw in.
Install the servos and pushrods again,
only this time, glue pushrod seals in
place with Goop. Mount your receiver
and battery pack with double sided tape
or Velcro.
Assemble the fuel tank and mount with
Velcro as well.
Mount the rudder and attach the
pushrod.
Screw the clevis in or out to center the
rudder. Check for correct rudder
movement.
Attach the throttle pushrod clevis to the
carb arm, and put an EZ connector in
the servo arm. Set the carb so that it is
slightly open with the trigger at neutral.
Open the throttle and check to see if you
get full open. If not, move the EZ
connector out farther on the servo arm,
farther in on the carb arm, or adjust your
throttle end point in your radio until it
does.