E A S Y V E E
43
Trim tabs level with bottom.
Radio box ready to go.
pushrods through the big end of the pushrod seals.
Attach both ends of the pushrods, making sure the
seals are on the outside of the radio box.
Use Goop or silicone to glue the pushrod seals to
the outside of the radio box. Make sure the seals
are centered on the pushrod holes. Allow to dry
.
Install your antenna. We used a piece of angled
plastic to mount our Deans base loaded antenna.
Setup
Adjust the stinger so that it is level and flat with the
bottom of the boat. This will be a zero setting.
Adjust your trim tabs so that they are parallel with
the bottom of the boat. Not angled up or down.
This is a zero setting.
Grease the flex cable.
Slide the cable through the stinger, into the engine
collet.
Leave a ¼ inch gap between the drive dog and
stinger.
Tighten the collet.
Wrap your receiver, failsafe and battery pack in
foam rubber.
Mount the switch.
Turn the transmitter on first, then the receiver.
Make sure the trims are centered.
Put the rudder servo arm on. It should be parallel
with the servo, and 90 degrees to the pushrod. Use
the sub trim function, if your radio has it. If not, get it
as close as you can.
Attach the rudder to the pushrod. Is the rudder
straight? If not, adjust the clevis or ball link until it is.
Be sure to put the screw in the servo arm…
Adjust the throttle so that the carb is wide open
when you pull the trigger all the way back, and