E A S Y V E E
41
Finishing
Once the hull is dry, wipe it down with alcohol. Use
a tack cloth lightly to remove any dust.
Spray a light coat of primer. Let this flash for a few
minutes, and spray a heavy coat on.
Let sit overnight.
When the primer is dry, use spot putty to fill any
nicks or surface imperfections.
When dry, wet sand with 400 on the rubber block.
If you are happy with the surface, spray on another
medium coat of primer.
When dry, wet sand with 600 or 800.
Use compressed air or a vacuum to remove the
dust on the inside and outside of the hull.
Wipe down the entire boat with alcohol.
Use a tack cloth to lightly wipe all surfaces.
Spray your color coats.
When cured, wet sand with 800+ and clear coat the
entire hull.
Make sure the clear is completely cured before final
assembly.
Apply your decals.
Wipe the area with alcohol, allow to dry.
Remove the backing from the decal. If you have
trouble removing the backing, press or squeegee it
firmly, and try again.
Align the decal and press firmly to surface. Roll or
squeegee in place. Remove transfer sheet from top
of decal.