E A S Y V E E
19
Completed radio box with lid.
Bottom chine rounded slightly.
Cutting the hull free of the jig.
Sand the entire box with 220.
Stand back and admire your awesome radio box!
Back to the boat:
Make sure that it has been at least 2 hours since
you glued the bottom sheeting to the hull.
With your plane, remove the overhang of the
bottom sheets at the sides.
Sand all over with 80. Do this while the boat is still
attached to the jig, as it is far easier than trying to
do it in your lap!
Round off the bottom, where the two bottom sheets
meet. Also slightly round the bottom to side
junction.
Do not round off the bottom to transom
junction, we need it sharp.
With your razor saw, cut all the tabs that are holding
your hull to the building jig.
Lift the hull straight up, to get it out of the two
supports holding the keel.
Ditch the jig. We don’t need it any more.
Hey, this is really starting to look like something
now!
After you finish admiring your cool new hull, let’s
move on.