31
805812 v1.04 05.20 HydroChill Install Instructions
Replacing water filter: every 12 months
The water filter has a 12 month or 132 000 litre capacity. The filter may
need to be replaced earlier, depending on local water quality conditions
and usage, or if you notice unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement.
Keep a towel handy to dry up any drips.
To change the water filter:
1. Turn off water supply to the filter.
2. Open the ambient tap for a few seconds to relieve line pressure.
3. Close the stop valve between the filter and the chiller.
4. Place a cloth or towel under the filter cartridge to catch any water
that may spill. Gently hold the filter cartridge and rotate the
cartridge a quarter turn to the left, then gently pull down, keeping
the cartridge level to avoid spills. Place spent cartridge in the sink
or suitable container.
5. Unpack the replacement cartridge and write today’s date where
shown on the label.
6. Remove the sanitary cap. Avoid touching the filter O-rings or filter
opening as this may cause bacterial contamination of the cartridge.
Slightly moisten the O-rings with regular tap water and align the
front cartridge label to the left.
7. Gently but firmly push the cartridge up into the filter head and
turn to the right, as far as it will go without forcing it. The cartridge
should now be locked in position, with the front label facing
forward.
8. The new filter should be flushed before use. Disconnect the filter
outlet hose from the stop valve, and place the open end of the
hose into a bucket or container. Turn on the water supply and flush
approximately 10 L through the filter.
9. Turn off the water supply and reconnect the hose to the stop valve.
10. Open the stop valve and turn on water supply.
11. Open ambient tap and run water to remove any air out of the line.
12. Wipe up any spills and dispose of the used cartridge and packaging
thoughtfully.
Maintenance
ROTATE
PULL DOWN
1
2
1
2
ROTATE
INSERT
