The product is an energy-saving automatic sensor lamp.
It can identify day and night. The lamp can be activated when someone enters the detection field
and can turn off automatically when they leave the detection field.
SPECIFICATION:
Power Source: 220-240V/AC Detection Range: 180°
Power Frequency: 50/60Hz Detection Distance: 5-12m(<24
!
)Adjustable
Ambient Light: <3-2000LUX (adjustable) Working Temperature: -20~+40
!
Time Delay: Min.10sec±3sec Working Humidity: <93%RH
Max.5min±1min Installation Height: 1.8-2.5m
Rated Load: 20W (1500LM) Detection Moving Speed: 0.6-1.5m/s
FUNCTION:
The sensor can identify day and night: You can adjust working states in different ambient light.
It can operate during the daytime and at night when it is adjusted on the “sun” position (max).
It can operate in ambient light less than 3LUX when it is adjusted on the “moon” position (min).
As for making adjustments, please refer to the testing and troubleshooting sections of this manual.
.
SENS adjustable: It can be adjusted according to using location. The detection distance of low
sensitivity could be only 5m and high sensitivity could be 12m which fits for large room.
Time - When the unit receives another induction signal during its first activation, it will restart
the timer from that moment, delaying the time it will shut down. This is added continually:
Adjustable Time Delay: the length of time delay could be set according to the customers’
requirement, the minimum time of this item is 10sec ± 3sec, the maximum is 5min±1min.
Good sensitivity Poor sensitivity
INSTALLATION:
Switch off the power.
Detatch the front of the fitting by removing
the two locking screws. Open the wire
hole in the backplate and pass the mains wire
through the hole. (Ensure that the rubber seal
is tight around the wire.)
Secure the Backplate to the mounting surface using the screws provided.
Connect the mains wire into the terminal block according to the connection-wire diagram.
Re-attach the cover onto the backplate, taking care
not to trap any loose wiring.
Switch on the power and then you can test the fitting.
The sensor head and two LED can tilt up/down,
turn left/right according to the customers’
requirement as the drawing shown right:
Instruction
INS ZN 35688 - D
Lynn 2 x 10W LED
With PIR Sensor
