Zimmer GPP5025N-00-A, Инструкция по установке и эксплуатации

Страница: 6 / 18

6
3 Proper use
NOTICE
The product is only to be used in its original state with its original accessories, with no unauthorized changes and
within the stipulated parameter limits and operating conditions.
Any other or secondary use is deemed improper.
►
Operate the product only in compliance with the associated installation and operating instructions.
► Operate the product only when it is in a technical condition that corresponds to the guaranteed parameters
and operating conditions.
Ö
Zimmer GmbH shall accept no liability for any damage caused by improper use. The operator bears sole
responsibility.
• The product is designed exclusively for pneumatic operation.
• The product is to be used as intended in enclosed rooms for temporary gripping, handling and holding.
•
The product is not suitable for clamping workpieces during a machining process.
• Direct contact with perishable goods/food is not permitted.
4 Personnel qualification
WARNING
Injuries and material damage due to inadequate qualification
If inadequately qualified personnel perform work on the product, this can cause serious injuries and significant
material damage.
►
All work on the product must be performed by qualified personnel.
►
Before working with the product, read the document in its entirety and make sure that you have understood
everything.
►
Observe country-specific accident prevention regulations and the general safety notices.
The following qualifications are a prerequisite for performing various work on the product.
4.1 Electricians
Electricians are able to perform work on electrical systems, can recognize and avoid possible dangers and know the
relevant standards and provisions due to their technical training, knowledge and experience.
4.2 Specialists
Specialists are able to perform the assigned work, can recognize and avoid possible dangers and know the relevant
standards and provisions due to their technical training, knowledge and experience.
4.3 Instructed personnel
Instructed personnel have been trained by the operating company on the tasks and possible dangers of improper behavior.
4.4 Service personnel
Service personnel are able to perform the assigned work and can recognize and avoid possible dangers due to their
technical training, knowledge and experience.
4.5 Additional qualifications
Persons who work with the product must be familiar with the valid safety regulations and laws as well as the standards,
guidelines and laws listed in this document.
Personnel who work with the product must have facility-issued authorization to commission, program, configure, operate,
maintain and also decommission this product.
Zimmer GmbH • Im Salmenkopf 5 •

77866 Rheinau, Germany •

+49 7844 9138 0 • www.zimmer-group.com
INSTALLATION AND OPERATING INSTRUCTIONS: GPP5000, GPD5000
DDOC00196 / m
EN / 2023-06-05