Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
38
INSTALLATION AND OPERATING INSTRUCTIONS:
2-jaw parallel gripper, electric, GEP2000IL-03 series
EN / 2021-06-25
DDOC01219 / a
13 Accessories/scope of delivery
INFORMATION
If any accessories not sold or authorized by Zimmer GmbH are used, the function of the product cannot be
guaranteed.
Zimmer GmbH accessories are specifically tailored to the individual products.
Please refer to our website for information on corresponding accessories.
14 Maintenance
Maintenance-free operation of the product is guaranteed for up to 10 million cycles.
The maintenance interval may shorten under the following circumstances:
• Dirty environment
• Improper use and use that does not comply with the performance data
• Non-permissible ambient temperature
Even though the product is maintenance-free as mentioned above, perform a regular visual inspection to check for any
corrosion, damage or contamination.
We recommend allowing maintenance and seal replacement to be carried out by Zimmer Customer Service.
Dismantling and reassembling the product without authorization may result in complications as special installation
equipment is required in some cases.
15 Transportation/storage/preservation
►
The transport and storage of the gripper must take place exclusively in the original packaging.
►
If the gripper has already been installed on the superordinate machine unit, care must be taken during transport to
ensure that no unintentional movements can occur. Before commissioning the machine after transport, check all power
and communication connections as well as all mechanical connections.
►
If the product is stored for an extended period, the following points are to be observed:
Ö
Keep the storage location as dust-free and dry as possible.
Ö
Avoid temperature fluctuations/observe and adhere to the temperature range.
Ö
Avoid wind/drafts/water condensation formation.
Ö
Package the product.
Ö
During storage, it must be kept away from direct sunlight.
►
Clean all components. There must be no dirt left on the components.
►
Visually inspect all of the components.
►
Remove all foreign substances.
►
Properly remove potential corrosion spots.
►
Seal electrical connections using suitable covers.
