6 Installation
ZIMM Screw Jack
22
Version 1.2
2015-01
6.6
Correcting the alignment
If necessary, the alignment can be corrected without much trouble.
The spindle must be greased (for more information see section
"7.2 Lubrication", page 25).
Fig. 16:
Correctly aligned screw jack - S version
1. Slacken the securing bolts on the gearbox casing and at the end of
the spindle.
2. Fully retract the jack (1).
3. Tighten the securing bolts.
4. Repeat the trial run (see section 6.5, page 21).
Fig. 17:
Correctly aligned screw jack - R version
1. Move the nut to the middle (1).
2. Slacken the securing bolts on the gearbox casing and on the end
bearing plate GLP.
3. Extend the nut to just before the end bearing plate (2).
S version
R version
1
1
3
2
