ZIMM GSZ Series, Инструкция по эксплуатации

Страница: 21 / 36

ZIMM Screw Jack 6 Installation
2015-01 Version 1.2 21
6.5 Trial running

The system must be installed and aligned.

The spindle must be greased (for more information see section
"7.2 Lubrication", page 25).
CAUTION
Lateral forces due to incorrect alignment!
Damage to the gearbox and spindle.
1. If the alignment is defective: Correcting the alignment, see
section 6.6, page 22.
2. Repeat the trial run.
High forces are generated!
Damage to the ZIMM Screw Jack.

Make sure that the limit switch (optional) and end bearings are not
overrun.

Make sure that attachments do not collide with other parts.

Run the screw jack over the complete travel in both directions.
When doing this, comply with the following:
– Run the screw jack slowly and carefully.
– As far as possible, run it with no load or with only a small load.
– Current consumption should be within the normal range, and
should be constant.
Major fluctuations indicate alignment errors and stresses.
– Monitor the temperature and avoid overheating, especially
where the travel is long and multiple runs are performed
successively.
– Avoid overrunning the limit switch (optional).