Ziegler CORN CHAMPION 10K, Инструкция по эксплуатации и сборке

Страница: 43 / 52

TROUBLESHOOTING
43
Picking Device
Malfunction Cause Remedy Page
The header comes to stand-
still during harvesting Drive belt is not tensioned Service Harvester
Manual
Operating speed too high Align
The ratio of straw is too high Picking plates Open up the picking plates as far as possible 23
Operating speed too high Align the operating speed to the conditions
Blockage within the picking
row Parallelism of the picking plates is
incorrect Adjust the picking plates 23
Foreign matter in or below the
picking row Remove dragged straw 30
Picking gap end Missing or incorrectly adjusted 23
Loss of corn cobs Operating speed Align the speed
Row spacing Align machine to conditions
Loss of corn Picking plates Adjust closer to each other
Return of the conveying chain of
the inlet chute Adjust the cover above the cross-auger lower 28
Operating speed Increase until the picker is better filled up with
material
The stubbles are too long
Horizontal cutting knife is worn If required, exchange blades 33
Crop divider heads Adjust to flatter position. Bring Picker closer to
the ground 22
Row spacing Unsuited
Operating speed Reduce speed
The picking plates are
blocked
Contamination Clean the mechanism. Open and close the
plates several times a day. 23
Hydraulic supply line Check 23
Standard setting Check 23
The machine does not run
smoothly and vibrates Horizontal cutting blade broken or
lost Immediately search for cause and, if required,
exchange knife 33