2-in-1 SMD Hot Air Rework Station
Model: ZD-8922
Important safety information
• When using electrical appliances basic safety precautions should always be
followed.
• Make sure that the voltage indicated on the rating plate corresponds with that of
the local network before connecting the appliance to the mains power supply.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children unless they are older than 8 and supervised.
• Do not operate the appliance with a damaged plug or cord, after a malfunction or
after being dropped or damaged in any way.
• If the supply cord is damaged, it must be replaced by a qualified engineer in order
to avoid injury or hazard.
• The soldering iron must be placed on its stand when not in use.
• Ensure there is sufficient space and ventilation around the appliance to allow the
escape of heat and/or fumes.
• Never place the product or part of it in water, or operate if your hands are wet.
• Wear appropriate clothing and safety goggles while soldering.
• Soldering work must be conducted on a stable, non-combustible surface.
• Do not touch any metallic parts near the soldering tip/nozzle.
• Do not leave the soldering iron unattended while it is switched on.
• Wash your hands thoroughly after working with solder.
• Make sure the power switch is in the “off” position and disconnect the plug when
the unit is not in use.
• Before storage, ensure the power is off and allow the station to cool down to room
temperature.
Features
• This 2-in-1 SMD hot air rework station is an excellent tool for soldering work.
• And it is super high cost-effective.
• It is suitable for soldering and desoldering all types of surface mounted IC, PCB or
components.
• The innovative heater and sensor provides a quick heat-up and rapid temperature
recovery.
• The hot air pump handle is embedded with sensor.
• The unit will immediately enter into Working Mode when you pick up the handle,
and will go into Standby Mode when you put the handle back to the holder.
