ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 66 / 160

ADJUSTMENTS AND TESTS UNDERWAY
Page 58
8.4 L4 - T
ROLL
T
HROTTLE
L
IMIT
The maximum amount of throttle command which is applied to the
engine, while the Trolling Valve is actively slipping the clutch, is set
with this function. This is adjustable from no increase in throttle
above Idle, to an increase of 20% of full throttle. The amount of
commanded throttle increases from Idle at minimum pressure to
Troll Throttle Limit at maximum pressure.
The values of this Function are 00% to 20% of Throttle Maximum.
Default Value is set to
00 .
A)Disconnect the Throttle Wire Harness from the CruiseCom-
mand Processor.
B) Connect the 8-Pin connector of the Service Field Test Unit to
the Processor Throttle connector and to the Throttle Wire Har-
ness. Refer to Figure 49:
C) Turn ON power to the Engine’s ECM. Ensure Power is On to
the Processor.
D)Depress either the Up or Down Arrow to activate the Function
Menu.
E) Use the Up or Down arrow to scroll to the L4 Function Code.
• The Multi Meter will read the Troll Throttle Limit output sig-
nal.
F) Activate Set-up Mode. Refer to Section 6.2.
G)Change the Value of the Function.
H)When the value required is displayed, store the value. Refer to
Section 6.2.
I) Remove the Service Field Test Unit and reconnect the Throttle
Wire Harness to the Processor.
Figure 58: L4 - Troll Throttle Limit Set-up Activated
NOTE: To read current, the mA Push Button on the Service Field Test Unit must be depressed.