ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 47 / 160

SET-UP PROCEDURES
Page 39
The throttle position drops to Idle and the transmission remains engaged
Ahead; the pause that follows is in proportion to the prior Control Head
lever position and how long the lever had been in that position before the
reversal.
The values of this Function are 00.0 to 16.0 seconds.
Default Value is set to 03.0 second pause.
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the C3 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to
Section 6.2.
6.3.16C4 - Reversal Pause Ratio
00 - 2:1 Ratio
This is the default setting and determines how the value set in the
Reversal Pause Time (
C3 ) Function is applied. The number of sec-
onds selected is for an Ahead to Astern maneuver only. An Astern
to Ahead maneuver will be 1/2 of the Reversal Pause Time selected.
This is the typical selection since most vessels do not reach the
same throttle in Astern as they would in Ahead. Therefore, the time
required to get to a sufficient water speed for a safe reversal is sig-
nificantly less.
01 - 1:1 Ratio
When this setting is selected, the value set in the Reversal Pause
Time (
C3 ) is the same for both Ahead to Astern, as with Astern to
Ahead maneuvers. This may be selected when the vessel reaches
the same water speed in both directions, as would be the case with a
Double Ended Ferry. Another application where this option may be
selected would be the control of a Bow or Stern Thruster.
The values of this Function are 00 2:1 (Default Value) and 01 1:1.
Figure 43: C3 - Reversal Pause Time Set-up Activated
Function Code is blinking