ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 42 / 160

SET-UP PROCEDURES
Page 34
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to Sec-
tion 6.2.
6.3.3 A2 - One Lever Operation
This System utilizes One Lever Operation Mode to allow one Control
Head lever to command all engines and gears at the same speed and direc-
tion. The advantage of this is that only one Control Head lever is active
at all times, which eliminates the possibility of shifting when the engine
RPM’s are not at Idle.
The values of this Function are 00 Disable (Default Value) and 01 Enable.
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the A2 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to Sec-
tion 6.2.
6.3.4 E0 - Select Engine Throttle Profile
Various engine manufacturers use different electronic interfaces for com-
manding the engine’s speed. In order to meet the diversity of these differ-
ent engines, the engine type must be entered. This value, in combination
with the Throttle Harness type, configures the throttle output profile to
meet the specifications of these various engines.
The values of this Function are:
01 = Caterpillar (PWM) (8-92%)
02 = Cummins Centry (voltage)(0.9 to 4.5VDC)
03 = Cummins Quantum (voltage) (0.9 to 1.2-4.0VDC)
04 = Detroit Diesel (voltage) (0.5 to 4.5VDC)
05 = MTU or MAN (current) (4.0 to 20mA)
06 = Scania (voltage) (0.4 to 3.0VDC)
(Default)
07 = Volvo (voltage) (0.5 to 4.5VDC)
Figure 36: A2 One Lever Operation Set-up Activated