ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 97 / 272

SET UP
Page5-21
5-6.4.2.2 Function Code C6 – ZF-Hurth Duty Cycle Ahead
5-6.4.2.3 Function Code C7 – ZF-Hurth Duty Cycle Astern
Figure 5-42: Display LED Function C6 Set Up
Activated
This function adjusts the maximum current available
to the Ahead Proportional Solenoid. Failure to limit
the current may result in permanent damage to the
solenoid.
The available Values are
00.0
to
100.0
percent Duty
Cycle of the applied voltage.
The Default Value is
100
%.
To determine, and if required, change the Value
(Refer to Sections 5-2 and 5-3, page 5-5):
A) Ensure that Troll is not selected (no rapidly
blinking LED).
B) Connect an amp meter in series with the Ahead
solenoid signal.
C) Move the Control Head lever to the Ahead
detent.
D) Scroll to Function Code
C6
.
E) Activate Set Up Mode.
F) Scroll Up or Down until the appropriate maxi-
mum current level is reached.
G) Store the Value to memory.
H) Return the Control Head lever to the Neutral/
Idle position.
Figure 5-43: Display LED Function C7 Set Up
Activated
This function limits the amount of current delivered
to the Astern Proportional Solenoid. Failure to limit
the current may result in permanent damage to the
solenoid.
The available Values are
00.0
to
100.0
percent Duty
Cycle of the applied voltage.
The Default Value is
100
%.
To determine, and if required, change the Value
(Refer to Sections 5-2 and 5-3, page 5-5):
A) Ensure that Troll is not selected (no rapidly
blinking LED).
B) Connect an amp meter in series with the
Astern solenoid signal.
C) Move the Control Head lever to the Astern
detent.
D) Scroll to Function Code
C7
.
E) Activate Set Up Mode.
F) Scroll Up or Down until the appropriate mini-
mum current level is reached.
G) Store the Value to memory.
H) Return the Control Head lever to the Neutral/
Idle position.
Function Code is Blinking