ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей, Страница: 93 / 272

SET UP
Page5-17
5-6.3.1.4 Function Code C3
– Proportional Pause Time
5-6.3.1.5 Function Code
C4
– Proportional Pause Ratio
00
- 2:1 Ratio
This is the default setting and determines how
the value set in the Proportional Pause Time
C3
Function is applied. The number of seconds
selected is for an Ahead to Astern maneuver
only. An Astern to Ahead maneuver will be 1/2
of the Proportional Pause Time selected. This is
the typical selection since most vessels do not
reach the same throttle in Astern as they would
in Ahead. Therefore, the time required to get to
a sufficient water speed for a safe reversal is sig-
nificantly less.
Figure 5-32: Display LED Function C2 Set Up
Activated
To change the Value (Refer to Sections 5-2 and 5-3,
page 5-5):
A) Scroll to Function Code
C2
.
B) Activate Set Up Mode.
C) Scroll Up or Down to the desired Value.
D) Store the Value to memory.
NOTE: I
F
C2 P
ROPORTIONAL
P
AUSE IS SET TO
02 F
IXED
N
EUTRAL
D
ELAY
E
NABLED
, F
UNCTION
C3 P
RO
-
PORTIONAL
P
AUSE
T
IME WILL SET THE
F
IXED
N
EUTRAL
D
ELAY DURATION
.
The Proportional Pause Time feature provides engine
deceleration, followed by a pause in throttling to the
commanded speed in the new desired direction, upon
a Full-Speed Reversal. This pause time is propor-
tional to how much throttle is being commanded and
for how long. In order to build up to the pause value
set, the vessel must be at full throttle and Ahead six
(6) times the pause set. The default pause from
Astern to Ahead is 1/2 the Proportional Pause
C2
value set.
When
C2
Proportional Pause is set to
00
, the throttle
position drops to Idle and the transmission remains
engaged Ahead; the pause that follows is in propor-
tion to the prior Control Head lever position and how
long the lever had been in that position before the
reversal.
This Function selects the amount of time that the
Clutch will stay engaged or at Neutral (depending on
C2
setting) while performing a Full Speed Reversal.
The available Values are
00
to
99
seconds.
The default Value is
03
seconds.
NOTE: T
HE
V
ALUE FOR THIS
F
UNCTION
C
ODE SHOULD BE DETERMINED DURING THE
S
EA
T
RIAL
.
Figure 5-33: Display LED Function C3 Set Up
Activated
To change the Value (Refer to Sections 5-2 and 5-3,
page 5-5):
A) Scroll to Function Code
C3
.
B) Activate Set Up Mode.
C) Scroll Up or Down to the desired Value.
D) Store the Value to memory.
Function Code is Blinking
Function Code is Blinking