ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 137 / 272

3
MMC-280 Rev.N 5/08
ZF Marine Electronics, LLC
Mukilteo Plant
This Service Sheet reflects all current variations of the standard 3-detent ZF Marine Electronics 400 Series Control Heads.
REQUIREMENTS
:
MicroCommander/ClearCommand: one (1) 8-Conductor Cable per Control Head lever.
Pluggable MicroCommander/ClearCommand: one (1) Control Head Harness per Control Head lever.
CruiseCommand: one (1) Control Head Harness per Control Head lever.
Included with the Control Head:
• Gasket
• Mounting screws and washers
• Terminals (For 8-Conductor or 1-Connector Harnesses)
• Watertight cable grip for the cable entrance on the Processor (For 8-Conductor)
When the Control Head is properly mounted on a console, it is spray proof from the top only. An adhesive gasket must be
used to seal it to the mounting surface. However, below the mounting surface it needs protection from water or spray.
Consider using a Weather Mount Enclosure, which is available from ZF Marine Electronics.
MOUNTING AND INSTALLATION:
A) Select the desired mounting locations and make cutouts per template. Refer to the Dimensions Diagram.
B) Check that the four mounting screws will start into the Control Head. Remove the Control Head from the cutout.
C) Remove the backing from the adhesive gasket and apply the gasket adhesive side to the console around the cutout.
D) Run cable/harnesses between Processor and Control Head. Label both ends with the Station ID.
(EXAMPLE: Port,
Center, or Starboard; Port Thrust, Port Throttle; etc.)
There are two types of Control Head connections available: Plug or Terminal Connected. Both types may be used with
MicroCommander, ClearCommand, or CruiseCommand using the appropriate cable or harness. Follow the appropriate steps
for the Control Head that has been supplied for your system.
T
YPE
1 - P
LUGGABLE
Plug Control Head cable into the pigtail at the Control Head.
(Ensure the correct Processor Cable is being plugged into
the corresponding Control Head lever pigtail)
.
When connecting the plugs, ensure that the release button or buttons are depressed and held until plug is fully connected or
disconnected. Connecting or disconnecting plugs without depressing and holding the release button or buttons will damage
the plug.
T
YPE
2 - H
ARD
-
WIRED
A) Strip back the PVC cover on the shielded cable approximately 2-1/2"
(63,5mm)
at the Control Head.
B) At the Control Head end of the cable strip and cut off the shielding and drain wire flush with the end of the PVC cover
(the drain wire at the Control Head is not connected to ground).
C) Strip 3/8"
(9,5mm)
insulation off each wire.
400 Series Control Head Variations
PART NUMBERING CONFIGURATIONS DETENTS AVAILABLE