ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 110 / 272

DOCK TRIALS
Page6-5
C) With the engine running, place the Station-in-Com-
mand’s lever into the Ahead Detent.
D) Measure the Shaft RPM at Idle with a Shaft Tach and
record on Table 6-1:.
E) Return the Control Head lever to the Neutral detent.
F) Move the Control Head lever to the Ahead detent.
G) Manually position the Troll lever to the point where the
Shaft rotation is 30 to 50% of that measured in Table 6-1:
above.
H) If not previously selected, enable Troll with Function
Code
L0
.
I) Depress the Transfer Button until the red LED begins
blinking rapidly (approximately 2 seconds).
J) Scroll to Function Code
L2
(Troll Minimum Pressure)
and activate Set Up Mode.
K) Scroll Up or Down until the push-pull cable aligns with
the troll lever.
L) Store the Value to Memory.
M)Return the Control Head lever to the Neutral Detent.
N) Repeat steps A) thru M) on the opposite side if required.
Table 6-2: Shaft RPM at Idle
Port Starboard