STANDARD OPERATING PROCEDURE
String Inverter Installation – Zeverlution Series
Version 1.2 Effective date 02/08/2017
Page 15 of 15
6.3.2
Connecting the inverter to the internet using Ethernet
To use this method the customers router must have DHCP enabled.
1.
Connect the Ethernet port on the
inverter to the Ethernet port on the
customers router directly via and
Ethernet cable or Ethernet bridge. The
Ethernet port in the inverter is labelled
‘ETH’.
2.
Run the Ethernet cable through the
comms gland on the bottom of the
inverter ensuring that the cable entry is
sealed from dust and moisture.
3.
The inverter automatically obtains an IP address from the router via DHCP and connects to the
internet. This process may take a minute or two.
4.
Press the button on the inverter display
to cycle through the menu until an IP
address is displayed. If the inverter is
connected to the internet ‘Connected’
should show beneath the IP address.
5.
Take a photo of the serial number and
reg. key of the inverter. The label is
usually placed on the right side of the
inverter. Upload this photo to google
drive as part of the installation photos.
