![background image](http://html1.mh-extra.com/html/zetron/4000-series/4000-series_installation-manual_3536674400.webp)
Appendix F: IntegratorRD Buttons
400
Select
Select
After the desired channel module is highlighted, the channel may be selected by pressing
the Select key. All other channels will be unselected. The channel name will be displayed
with a green background to indicate the channel is selected.
Simul Select
To select more than one channel at a time, press the Simul Select key. Then highlight the
desired channels. When complete, press the Simul Select key again. While Simul Select is
active, highlighting an already selected channel will unselect the channel.
CAD
Disable CAD
This button is only needed when the console has a CAD (Computer Aided Device)
interface connected to it through a serial port. This button disables the CAD control over
the console while allowing console activity messages to be sent to CAD. When this button
is activated, a countdown timer is started and displayed in the system message area. The
timer indicates the amount of time before the CAD-disable condition will be automatically
removed. Pressing the Disable CAD key while CAD-disable is active will cause the
disable to cancel, allowing CAD control over the console.
Page Control
Page Safety
If a Page Safety key has been defined, any instant call page key that is pressed just selects
the page for sending. As many pages as desired may be selected for sending. The pages are
not sent until the Page Safety key is pressed. Once this key is pressed, IntegratorRD will
send pages in the same order in which they were selected, pushing each subsequent
selection to the end of the selection list. During the selection process, if a page is
unselected from the list, it is removed. If the same page is subsequently added again, it is
pushed to the back of the list. When Page Safety is pressed, pages are sent in the order of
their final selection.
Note
The button, ‘Disable CAD’ is only needed when the console has a
CAD interface connected to it through a serial port. This button
disables the CAD control over the console while allowing console
activity messages to be sent to CAD. CAD stays disabled for 256
seconds, or, to re-enable it, press the button again.
Содержание 4000 Series
