ZEROXCLUB Instructions Manual
8
2.4.3 Adjust the Camera View
●
You can use the camera mount to mark where to drill holes
which is wide enough for the 4 pin connector.
●
Adjust the camera to the correct angle as needed. The camera
should be adjusted to a horizontal position relative to the ground in
order to provide the best view of the objects behind the vehicle.
●
When the preferred view for each camera is obtained, tighten the
screws to prevent the camera angle from deviating due to vibration
during driving.
NOTE:
One important thing to note here is that the camera
should face backward and that its view is not obstructed in any
way. You should also make sure that the camera sits properly,
and that a simple car bump or jerk, will not loosen it in any way.
The third caution is making sure that the installation spot is not
too far away and that it fits the cable length.
2.5 Camera-Cables Installation
●
Define the routing of each of the camera cables. Connect the
camera cable to the extension cable provided in the system (you
can coil up the unused part if you need shorter feet), and run the
extension through the car to the dash area.
