The Zeroplus Logic Analyzer
Installation Guide
The Zeroplus Logic Analyzer Installation Guide
Page 16
2.3 Tips
and
Advice
1. When testing a circuit board, make sure that the internal sampling frequency (within
the Logic Analyzer) is at least four times the external board frequency.
2.
If the signal connector does not work well with the pins on the test board, try using the
supplied probes.
Fig. 2-7: Probes supplied with the Zeroplus.
Fig. 2-8
Fig. 2-9
3. Usages of probes
3-1. Take the loose end of the cable and
insert it into the clip.
3-2. Compress the probe as shown to
reveal 2 metal prongs (Fig.2-8).
3-3. Place the metal prongs on a metal
connector on the motherboard and
release the fingers so that the
prongs grip the metal connector
(Fig.2-9).
