33
22.0 REPLACING ROTOR BLADES
To remove and replace the rotor blades, please follow the instructions below.
1.
Unscrew the two screws on the top of the rotor blades using the supplied
screwdriver. It is advised that you replace the blades one at a time to avoid
losing screws or installing blades incorrectly.
2.
Remove the copper plate cover from the blade clamp.
3.
Replace the rotor blade with a replacement blade marking sure to match
with motors.
4.
Firmly press the blade into position making sure that you have aligned the
motor stem with the hole in the rotor blade.
5.
Lock the blade into position by putting the copper plate cover back over
the screws that were removed in step 1 making sure not to over tighten.
NOTE
• It is important that the correct rotor blades are installed on the correct motors as if
they are installed incorrectly the Drone will not fly and you could potentially burn out
the Drone’s motors.
• Be aware of the sharp edges on the blades. Please handle them with care.
• Only use the Drone blades supplied with this unit. Do not mix with other blades.
• To avoid injury do not touch the blades when they are spinning.
• Only use blades that are in good condition. If they are chipped or broken replace
them as this may compromise the flight.
A
B
B
A
