ZERO-X Raven+, Руководство пользователя, Страница: 14 / 20

_14
Capture the skies. ™
4.4 SPEED MODES
The Raven+ has 3 speed modes that control the acceleration and
maneuverability of the drone. To cycle through the Speed Modes, use
the Speed Button marked H/L on the top right of the controller.
(Refer to
Fig 2.2.2 page 8 for button selection)
LOW
When the Raven+ is powered up it will start in LOW speed mode.
In this mode the Raven+ will control and fly slowly. It is advised that
beginners use this mode to learn the basics before moving onto the two
higher modes.
MID
Push the Speed Button once and the Remote Control will beep twice
indicating that the Raven+ is now in the medium Speed Mode.
In this mode the sensitivity of both the acceleration, and directional
control of the Raven+ will be increased, making the Raven+ more nimble
and quick.
(Refer to Fig 2.2.2 page 8 for button selection)
HIGH
Push the Speed Button a second time and the Remote Control will beep
three times indicating that the Raven+ is now in its highest Speed Mode.
(Refer to Fig 2.2.2 page 8 for button selection)
In this mode the sensitivity of both the acceleration and directional
control will be increased again. It is advised that this mode is only used
in a very open space once the pilot has gained significant drone flight
experience.
4.5 TRIMMING
Trimming is used to balance the Raven+ when flight is off centered.
Please check before attempting to use trimming that the Raven+’s flight
is not being affected by outside forces such as wind.
(Refer to Fig 4.5.1)
Trimming
Pitch
To trim the Raven+s’ pitch, use the Pitch
Trim Controller which is the small switch
on the Remote Control to the left of
the Right Thumbstick. This will balance
the forward and back movement of the
Raven
+
.
Trimming
Roll
To trim the Raven+s’ roll, use the Roll
Trim Controller which is the small switch
on the Remote Control below the Right
Thumbstick. This will balance the left and
right movement of the Raven
+
.
Trimming
Yaw
To trim the Raven+s’ yaw, use the Yaw
Trim Controller which is the small switch
on the Remote Control below the left
Thumbstick. This will balance the left and
right spin of the Raven
+
.
*Fig 4.5.1