ZoningBOX 6 / ZoningBOX 4
Technical Support:
32
ETS PARAMETERISATION
Figure 24.
Grilles - Configuration
After enabling Grille Control from the General parameter screen (see section 2.1), the
following options will be available for configuration:
Grille
“y”
[
disabled
/enabled
]: sets how many grilles (i.e., zones) will be
controlled by the device, up to six. By enabling a grille, the following objects
will become available:
➢
“
[Gy] [Actuator] Grille Position
”, one-bit object (or one-Byte for positional
control) which should be sent the grill control signal. This object is typically
to be grouped together with the corresponding object of the Zones module
(see section 2.2.1).
➢
“
[Gy] [Actuator] Grille Status
”, one-bit object (or one-Byte for positional
control) which will report the current state of the grille whenever it changes.
This object is typically to be grouped together with the analogous one of
the Zones modules (see section 2.2.1).
Error Notification
[
disabled
/enabled
]: enables o disables the “Error
Notification” tab on the left menu. See section 2.3.3.
2.3.2
GRILLE
The configuration of a grille entails setting up the following options:
An
opening time
for the connected grille (
positional mode
exclusive).
