LUMENTO X4
LED DIMMING
RGB CONTROLLER
ZN1DI-RGBX4
Technical Documentation
© Zennio Avance y Tecnología S.L. Edition 4 For further information
www.zennio.com
Page.
2
of
2
WIRING AND ASSEMBLY DIAGRAMS
Recommended installation:
NOT recommended:
Vertical position.
If there is not any
other possibility,
install terminal block
up (see fig.)
OUTPUTS SPECIFICATIONS AND CONNECTIONS
Maximum current per channel
2.5A @ 25ºC ambient temperature
Number of channels
4
Total power connected
120W (12VDC) or 240W (24VDC)
Connection type
Pluggable screw terminal block
Cable section
1.5 to 2.5mm²
Load type
Common anode
Shortcut protection
Yes
Overheating protection
Yes
LED
The LED load is connected to the terminal block, matching the anode or the anode common
terminal of the LED stripes with C (anode). The cathode can be connected to several output
channels if it is necessary more than 2.5A (up to 10A) for the LED strip,
as long as the length
and section of the wires used for the connections between the outputs and the strip are
the same.
Correspondence
C
: Anode
1
: Red
2
: Green
3
: Blue
4
: White
Assembly:
Screw mounting, 2 holes of
3.5mm diameter. Screws
not included.
External power supply:
+ and - terminals of
external power supply 12
or 24VDC
SAFETY INSTRUCTIONS
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each
country.
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for the
entire KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the
wires of other accessories, in case of being installed.
Once the device is installed, it must not be accessible from outside.
Keep the device away from water and do not cover it with clothes, paper or any other material while in use.
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the
instructions at http://zennio.com/weee-regulation.