Z70 v2
108
ANNEX III. REMOTE CONTROL VIA IP
Z70 v2 feature an Ethernet interface that makes it possible to perform actions over the device
by means of remote IP applications. This brings the option to control its functions analogously
as if the device were actually being controlled on site.
Z70 V2 CONFIGURATION
In order to be able to control Z70 v2 from remote applications it is necessary that the integrator
enables in ETS the parameter
Remote control through the Internet
inside the " Configuration"
tab (see section
¡Error! No se encuentra el origen de la referencia.
).
Also, before being able to control the device remotely, it is necessary to make a previous pairing
between the remote application and the Z70 v2. This pairing is done in the configuration page,
where the pairing box is located.
Figure 113.
Device Pairing box
In the upper right corner there is a service state indicator. This indicator will be automatically
updated if the state changes.
Service state
Icon
The device has not license for remote control
No network connection
The service is not available
Conexión and service OK
Remote control in process (remote device currently connected)
Table 9
Service States
