Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
71
I the option Use DHCP Server is enabled, the IP address can be found out
by pressing the main button of the unit 5 times after starting.
Define ID
: when enabled the following parameter appear:
➢
Outdoor Unit ID
: numerical identifier of GetFace IP (field
Phone Number
(ID)
, in
Services
Phone
).
Note
:
This parameter is only available when the parameter The Outfoor Unit
is in a Different network is disabled
.
Number of Doors
: up to 3 doors per outdoor unit.
Important
:
the Door concept in Z41 COM refers to the switches configured in
GetFace IP in section Hardware
Switches
.
Opening Settings
➢
HTTP Command
: the order to open a door will be sent via a HTTP
command. When enabled, the following parameters appear:
•
Secure Opening
: allows setting a
username
and
password
required to
send through the HTTP command to open de door in order to increase
the security (must match with the ones set in GetFace IP in section
Services
HTTP API
).
➢
KNX Object
: the order to open a door will be sent via the communication
object
“
[VI n] Switch X
”, where X is the number of the door. It is possible to
choose the
value of the object
that will open the door
(“1 = Open” or “0 =
Open
”).
Automatic Door Opening (DOORMATIC)
: allows opening the doors
automatically when receiving a call.
➢
Door n
: door/s responding to the automatic opening.
➢
Initial Status after ETS Download
: sets whether the automatic opening is
enabled or not after ETS Download. It also can be changed at runtime
through the object “
[VI n] Enable Automatic Door Opening
”.
➢
Disable if “Do Not Disturb” Mode Is Active
: disables the automatic door
opening when do not disturb mode is active.
