Roll-ZAS
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
6
It is advisable to check the proper insertion of the device, making sure that only the
profile outline of ZAS stands out of the appliance box and that the metal sheet stays
hidden.
This device does not need an additional power supply as it is entirely powered through
the KNX bus.
Figure 2 shows the element diagram of the ZAS controller.
Figure 2.
ZAS. Element Diagram.
A short press on the programming button (3) will set ZAS into the programming mode,
which will make the programming LED (4) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, ZAS will enter
the secure mode. The LED will then blink in red.
Apart from the programming button (3), and particularly once the device has been
installed or the button is not inaccessible, it will be possible to enter the programming
mode from the touch interface itself. In the factory state, after being connected to the
KNX bus and prior to any type of download, the device will show a default interface
with little functionality, which, however, will commute between pages “1” and “C”
(Configuration) by pressing the “Menu” button (upper left button). Under page “C”,
1.- KNX connector
2.- Temperature sensor
3.- Programming button
4.- Programming LED
5.- Inputs (A/D)
6 - Magnet
7.- Touch button
8 - Display
9.- IR receiver
10. Central touch area
