Roll-ZAS
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
19
Initial Update.
This function sets whether ZAS, after recovering from a failure
of the KNX bus, should send read requests for the updated value of the
general indicators (if they were enabled by parameter) and for the “[General]
Time” object, as well as for the updated status of the objects associated to
the touch buttons. In addition, a certain delay can be parameterised in order
to ensure the availability of external devices that may have been affected by
the bus failure as well (for an immediate sending, just set this field to 0).
Note
:
if this function is not enabled by parameter, the device will resume the
state the objects had before the bus failure
.
Remote Control.
Enabling this option under the General menu will activate
the IR reception, therefore making it possible to control ZAS from the remote
control.
Figure 13
. Remote Control
The following options will be available under the specific tab that shows up:
Action Buttons only for Page 1?
: this parameter sets if the action
buttons of the remote control (see Figure 7) will only control the
configuration established for page 1 (option "Yes") or if they will simulate
the behaviour of the buttons of all (1-4) the configured pages (option
"No").
Restricting the control to only Page 1 implies that any press made over
the Menu button or the Arrow buttons on the remote control will be
ignored (navigating to other enabled pages will not be possible from the
