MAXinBOX Hospitality
Technical Support:
18
2.7
MANUAL CONTROL
MAXinBOX Hospitality allows manually switching the state of its output relays through
the respective pushbuttons on the top of the device. A specific pushbutton is therefore
available per output.
Manual operation can be done in two different ways, named as
Test On Mode
(for
testing purposes during the configuration of the device) and
Test Off Mode
(for a
normal use, anytime). Whether both, only one, or none of these modes should be
accessible needs to be parameterised in ETS. Moreover, it is possible to enable a
specific binary object
for locking and unlocking the manual control
in runtime.
Notes
:
The available control modes (Test On / Test Off) and the lock object can be
enabled and disabled in MAXinBOX Hospitality
independently for the relay
outputs
(binary or shutter)
and for the fan coil outputs
(valves and fan).
The
Test Off mode
will be active (unless it has been disabled by parameter)
after a download or a reset with no need of a specific activation
– the
pushbuttons will respond to user presses from the start.
On the contrary, switching to the
Test On mode
(unless disabled by
parameter) needs to be done by long-pressing the Prog./Test button (for at
least three seconds), until the LED is no longer red and turns yellow. From
that moment, once the button is released, the LED light will remain green to
confirm that the device has switched from the Test Off mode to the Test On
mode. After that, an additional press will turn the LED yellow and then off,
once the button is released. This way, the device leaves the Test On mode.
Note that it will also leave this mode if a bus power failure takes place
.
This device is delivered from factory with the Test On and Test Off modes
already
enabled in parameters
for all outputs.
