Technical Documentation
© Zennio Avance y Tecnología S.L. Edition 3 Further information
www.zennio.com
Page
1
/
2
MAXinBOX 8
MAXinBOX 8. Multi-function actuator with 8 outputs 16A
ZN1IO-MB8
Technical Documentation
FEATURES
8 different configurable outputs:
Shutter channels (up to 4).
Individual outputs (up to 8).
Manual output operation with push button and LED
status indicator.
Suitable for capacitive loads, maximum
140 µF
.
Logical functions included.
Output timing facilities.
Total data saving on power failure
Size 67 x 90 x 80 mm (4.5 DIN units).
DIN rail unit assembly (EN 50022), with snap fit clamp.
No external power supply required other than the bus.
KNX BCU integrated.
Possibility to connect different phases in adjoining
outputs.
CE directives compliant.
Programming/test button
: short button press to set programming
mode. If this button is held while plugging the device into the KNX
bus, it goes into safe mode. If this button is held more than 3
seconds, the device goes into manual mode (test mode)
LED:
programming mode indicator (red). When the device goes into
safe mode, it blinks (red) every half second. The manual mode is
indicated by the colour green. During start up (after reset or power
failure) and if the device is not in safe mode, LED blinks in blue for a
few seconds
6
1
4
5
7
3
2
Figure 1. MAXinBOX 8
GENERAL SYSTEM SPECIFICATIONS
CONCEPT
DESCRIPTION
Type of device
Electric operation control device
KNX supply
Voltage (typical)
29VDC SELV
Voltage range
21
…31V DC
Maximum consumption
160mW
Bus connection
Typical bus connector TP1, 0,50 mm² section
External power supply
No
Ambient temperature
from 0ºC to +55ºC
Storage temperature
from -20ºC to +70ºC
Ambient humidity
5 to 95% RH (no condensation)
Storage humidity (relative)
5 to 95% RH (no condensation)
Complementary characteristics
Class B
Safety class
II
Operation type
Continuous operation
Device action type
Type 1
Electrical solicitations period
Long
Type of protection
IP20, clean environment
Assembly
Independent control assembly device to be mounted inside of electrical panels
with DIN rail (EN 50022).
KNX bus failure response
Data saving and relays open if channel configured as shutter.
Response when restarting KNX bus
Data recovering and output status change according to programming when
recovering.
Operation indication
Programming LED indicates programming mode (red) and test mode (green).
Output status LED indicators reflect current output state.
Weight
284
g.
PCB CTI index
175 V
Enclosure
PC FR V0 halogen free
1
. Upper
outputs
2
. Lower output
screws
3
.Programming/Test
LED
4
.KNX
connector
5
.Programming/Test
button
6
.Output control
button
7
.Output status LED
indicator
