IRSC Zone
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
10
turned OFF, an order to close the grille is sent to the bus, after which the
setpoint of the zone is not considered anymore (until the zone is turned on
again) for the calculation of the central setpoint.
Zone X – ON/OFF Status
: indicates the current state (ON/OFF) of the
corresponding zone.
Zone X – Setpoint
: permits receiving orders from the bus to change the
desired setpoint temperature (in ºC) for the corresponding zone.
Zone X – Setpoint Status
: indicates the current value (in ºC) of the setpoint
temperature of the corresponding zone.
Zone X – Grille control
: sends orders (“0”=Close, “1”=Open) to the bus to
control the airing grille of the corresponding zone.
Zone X – Grille Status Reception
: permits the arrival from the bus of
open/close orders for the airing grille of the corresponding zone, which –when
appropriate– makes the device respond sending an updated order to the bus
through the “Zone X – Grille control” object.
Zone X – Reference temperature:
permits the reception from the bus of a
reference temperature, for example measured by a sensor installed inside the
corresponding zone.
If more zones are enabled (see section 3.2), the same seven objects will be available
for the remaining zones, with a different value for “X” in each case.
When entering the parameter edition of IRSC Zone for the first time, the following
window will be shown:
Figure 5.
Configuration screen by default
