Zennio inBOX 20 v2, Руководство пользователя

Страница: 10 / 30

inBOX 24 v2 / inBOX 20 v2
http://www.zennio.com Technical Support: http://support.zennio.com
10
2.3 OUTPUTS
The inBOX 24 / 20 v2 actuators incorporate 2 relay outputs , each configurable as a:
Individual binary outputs , which allows an independent control of loads.
Shutter channel , which allow controlling the motion of shutters or blinds.
For detailed information about the functionality and the configuration of the related
parameters, please refer to the following specific manuals, all of them available in the
inBOX 24 / 20 v2 product section at the Zennio homepage ( www.zennio.com ):
Individual outputs.
Shutter channels.
2.3.1 MANUAL CONTROL
inBOX 24 / 20 v2 allows manually switching the state of its output relays through the
respective pushbuttons on the top of the device. A specific pushbutton is therefore
available per output.
Manual operation can be done in two different ways, named as Test On Mode (for
testing purposes during the configuration of the device) and Test Off Mode (for a
normal use, anytime). Whether both, only one, or none of these modes can be
accessed needs to be parameterised in ETS. Moreover, it is possible to enable a
specific binary object for locking and unlocking the manual control in runtime.
Note :
The Test Off mode will be active (unless it has been disabled by parameter)
after a download or a reset with no need of a specific activation
– the
pushbuttons will respond to user presses from the start.
On the contrary, switching to the Test On mode (unless disabled by
parameter) needs to be done by long-pressing the Prog./Test button (for at
least three seconds), until the LED is no longer red and turns yellow. From
that moment, once the button is released, the LED light will remain green to
confirm that the device has switched from the Test Off mode to the Test On