HeatingBOX
http://www.zennio.com
Technical Support:
http://support.zennio.com
6
Outputs (2)
: output ports for the insertion of the stripped cables of the systems
being controlled by the actuator. Please secure the connection by means of the
on-board screws.
Manual control pushbuttons (3)
:
pushbuttons for a direct control of the
outputs during the set-up process. See section
2.5.
To get detailed information about the technical features of this device, as well as on the
installation process and on security procedures, please refer to the corresponding
Datasheet
, bundled with the original packaging of the device and also available at
www.zennio.com
.
1.3
START-UP AND POWER LOSS
During the start-up of the device and depending on the configuration, some specific
actions may be performed. For example, the integrator can set whether the outputs
should change to a particular position and whether the device should send certain
objects to the bus after the power recovery. Please consult the next sections of this
document for further details.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
