HeatingBOX
http://www.zennio.com
Technical Support:
http://support.zennio.com
5
1.2
INSTALLATION
HeatingBOX connects to the KNX bus through the on-board KNX connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application programme may be downloaded.
Figure 1.
HeatingBOX 230V 8X.
Note
:
the above element diagram is slightly different for HeatingBOX 230V / 24V 4X,
although entirely analogous
.
The main elements of the device are described next.
Test/Prog. Pushbutton (5)
: a short press on this button sets the device into
the programming mode, making the associated LED (5) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the device
will enter into
safe mode
. In such case, the LED will blink in red every 0.5
seconds
.
Phase Inputs (1)
: slots for the connection of the voltage lines (phase). Both
inputs are internally shorted.
3
2
7
5
4
6
1
1.
24V / 230V power inputs (phase).
2.
Valve outputs.
3.
Manual control pushbutton.
4.
Output status LED.
5.
Prog./Test pushbutton.
6.
Prog./Test LED.
7.
KNX connector.
