Zennio GetFace IP
Tecnical Support
30
3.1.7
TAMPER SWITCH CONFIGURATION
The
tamper switch
does not require extra configuration. The function of this accessory
is warning when the video intercom is being manipulated. For that purpose, it must be
connected to a KNX input or any monitoring system. That connection will remain closed
after the Zennio GetFace IP frame has been installed. On the other hand, it will be
open once the frame gets removed.
3.1.8
ACCESS CONFIGURATION WITH TOUCH-DISPLAY
The Touch Display module (ZVP-TOUCH) allows making phone calls an opening the
lock. To configure this module is necessary to enter the
Hardware
Display
section
of the web
interface.
DISPLAY
The basic settings are configured in this section.
Phone Book Displayed
: allows providing an orderly user phone book
through the Touch Display.
Entry Keypad
:
enable the keypad type
.
Note
:
to activate the keypad which allows to make calls to users with
Virtual
Number
, enable the parameter
Dial User Virtual Number by Numeric
Keypad
(see section 3.2.4.3).
Language Settings
: sets the main language for the on-screen controls.
Prefer Icons to Text
: when enabled, the display module will only show icons.
Power saving mode
: activates the power saving mode in which the display
brightness is reduced
.
PHONE BOOK
The appearance of the phone book is configured in this section. Users can be
distributed into groups ordered into up to four levels.
