DIMinBOX 2CH
DIMinBOX 2CH. Two channel universal DIMMING actuator for lighting control
ZDI-DB2C
Technical Documentation
© Zennio Avance y Tecnología S.L. Draft Edition Further information
Page
4
/
4
Technical Documentation
OUTPUT SPECIFICATIONS
SAFETY INSTRUCTIONS
Do not connect the mains voltage (110-230VAC) or any other external voltages to any point of the KNX bus.
Connecting an external voltage might put the entire KNX system at risk.
Once installed, the device must not be accessible from the outside.
In case of changing load, disconnect the main voltage (110-230VAC).
Installation should only be performed by qualified electricians following applicable regulations on preventing
accidents, as required by law.
Ensure there is enough insulation between the AC voltage cables and the KNX bus cables.
Keep away from water or humidity and do not cover the device with clothes, paper or any other material when
in use.
Not observing these safety instructions may cause fire or other hazards.
OUTPUT SPECIFICATIONS
Contact type
Semiconductor switching device
Load protection
Yes; overheating, voltage surge and short-circuit protection.
Switching capacity per output
RLC: 310W (230VAC) or 160W (110VAC) @ 25ºC (50-60Hz)
CFL and LED lamps: 125W (230VAC) or 65W (110VAC) @ 25ºC (50-60Hz)
Dropping voltage
Negligible
Connection type
Cable screw terminal
Recommended cable section
0,25 mm² to 2,5 mm²
Cable type
Stranded or solid wire
Response time
Negligible
Common
Input 1
Input 2
Common
Input 1
Input 2
Each channel load, see table
“output specifications”
Independent channel connection
Common channel connection
110V/50Hz
230V/50Hz
RLC: 20-600W (230VAC)
20-230W (110VAC)
CFL and LED: 10-250W (230VAC)
5-125W (110VAC)
110V/50Hz
230V/50Hz
DRAFT
EDITION
