ALLinBOX 1612 v2
Technical Support:
30
2.11
MANUAL CONTROL THROUGH IR REMOTE CONTROL
ALLinBOX 1612 v2 enables the manually switching the state of its output relays
through the pushbuttons of an IR remote control. A specific pushbutton on the IR
remote control is therefore available per output.
Figure 15.
IR Remote Control
Manual operation has the mode, named as
Test On Mode
(for testing purposes during
the configuration of the device). From ETS it will be possible to configure if the manual
control will be available. Moreover, it is possible to enable a specific binary object for
locking and unlocking the manual control in runtime.
Note
:
Switching to the Test On mode (unless disabled by parameter) needs to be
done by long-pressing the Prog/Test button (for at least three seconds), until
the LED is no longer red and turns yellow. From that moment, once the
button is released, the LED light will remain green to confirm that the device
is in Test On mode. After that, an additional press will turn the LED yellow
and then off, once the button is released. This way, the device leaves the
Test On mode. Note that it will also leave this mode if a bus power failure
takes place
.
