ALLinBOX 1612 v2
Technical Support:
7
1.3
START-UP AND POWER LOSS
During the start-up of the device, the Test/Prog. LED will blink in blue colour for a few
seconds before ALLinBOX 1612 v2 is ready. External orders will not be executed
during this time, but afterwards.
Depending on the configuration, some specific actions will also be performed during
the start-up. For example, the integrator can set whether the output channels should
switch to a particular state and whether the device should send certain objects to the
bus after the power recovery. Please consult the next sections of this document for
further details.
On the other hand, when a bus power failure takes place, ALLinBOX 1612 v2 will
interrupt any pending actions, and will save its state so it can be recovered once the
power supply is restored.
For safety reasons, all
shutter channels
will be stopped (i.e., the relays will open) if a
power loss takes place, while the individual outputs and fan coil contacts will switch to
the specific state configured in ETS (if any).
